GEN2 PRUSA CORE ONE KIT

Add modular 3D printable storage to your Prusa Core One with this custom GEN2 kit. It installs directly under your printer and supports all GEN2 drawers up to 240mm in length, giving you quick-access storage without taking up extra desk space.

Drawers can be swapped, expanded, or rearranged at any time.

RECOMMENDED ADD-ONS

240
Prusa Tool Insert - Core-One/MK4
Compatible with 240-2W-1H drawers

240-3W-1H
GEN2 PlateStack Case - Core-One/MK4
A modular build plate holder that can be stacked

HARDWARE - PURCHASED
(Includes affiliated links to help support the project)

Filaments

PETG - More durable, flexible, slides smoother, but can warp
PLA - Easy to print

M3 Nuts & Screws

Reliable fasteners for some GEN2 assembly

Magnets

Optional for magnetic functions

Standard Strength:
(Adequate for most)
10x2mm or 6x2mm
Very Strong (N52)
(May be too strong for smaller drawers)
10x2mm or 6x2mm

OVERVIEW AND TUTORIAL

INSTRUCTIONS - (GEN2 2H FEET ONLY)

GEN2 2H feet are optional for additional storage, otherwise please proceed with video instructions for GEN2 1H feet

STEP 1: 2H Feet Installation

GEN2 2H Feet for the Prusa Core One installs the same as 1H feet but include brackets to utilize more mounting locations. (The rest of the installation can be followed along in the video tutorial)

• Install both L & R GEN2 QuickLocks into the GEN2 cases

• (Optional) Install Magnet Clips with magnet into case if using along with a drawer for magnet pull when closing.

• (Optional) Install Drawer Stoppers in the bottom front of the case, these prevent the drawer below from being pulled out all.

STEP 2: 2H Rear Foot Installation

• Attach the Rear Left Foot to the body of the Prusa Core One using two M3-16mm screws, don't fully tighten.
(If alignment is difficult slightly loosen nearby screws on the core one frame to allow more play, full tighten after installing foot.)

• Press/Pull M3 nuts into the hex slots of the Rear Foot Bracket.

• Align Rear Foot Bracket with holes and hold the bracket on the inside of the lip of the Prusa Core One, Insert M3-16 screws through the two outermost holes of the Rear Left Foot, thread into the hex nuts in the Rear Foot Bracket.

• Tighten all four screws.

•🔃Install Rear Right Foot - same process mirrored

STEP 3: 2H Front Foot Installation

• Attach the Front Left Foot to the body of the Prusa Core One using two M3-16mm screws, don't fully tighten.
(If alignment is difficult slightly loosen nearby screws on the core one frame to allow more play, full tighten after installing foot.)

• Press/Pull M3 nuts into the hex slot of the Front Foot Bracket.

• Align Front Foot Bracket with the hole closest hole of the Core One frame, hold the bracket on the inside of the lip of the frame, Insert a M3-16mm screw through the single outermost holes of the Front Left Foot, thread into the hex nut in the Front Foot Bracket.

• Tighten all four screws.

•🔃Install Front Left Foot - same process mirrored