INSTRUCTIONS

GEN2 COVER SIZE ADAPTER

The GEN2 SIZE ADAPTER COVER Allow you to attach a GEN2 shorter drawer on top of a longer drawer in a table top kit configuration. The cover adapters can be interchanged any of the top most covers on the Table Top Kit V2 kits. "Cover - Upper"

Check out this video for a quick overview of the Table Top Kit V2 assembly (Keep in mind these adapters replace the top-most covers) ►

STEP 1: Install nuts into GEN2 SIZE ADAPTER COVER

• Using an M3x8mm screw pull the M3 nut into the slots on the underside of the Adapter Cover.

NOTE: You do not have to fill in every nut slot, you can install only one to support the length of drawer you will be installing.

STEP 2: Mount shorter GEN2 Case to SIZE ADAPTER COVER

• Slide shorter GEN2 drawer into place on the cover. Use a M3x6mm screw to lock it in place

NOTE: Make certain the shorter GEN2 Case slides onto the rails before securing with the screw.

STEP 3a: Install On Table Top Kit V2

NOTE: The GEN2 Size Adapter is an alternative cover to the original GEN2 Table Top Kits V2's "Cover-Upper" parts. In this example we will replace an existing "Cover-Upper 1W".

• On the GEN2 Table Top Kit V2 remove the original cover part "Cover-Upper", remove the M3x6mm screw near the top back and full remove the cover.

• Slide the new Size Adapter Cover in place of the cover you just removed, secure it use an M3x6mm screw.

STEP 4: Completion - Assemble Shorter Drawers

• You can now continue to add onto the shorter length drawer case you added. Use the Table Top Kit V2 Covers for the shorter drawer size to complete the assembly.

NOTE: In this example I shared only assembling 1W section of the shorter drawers, but you can continue to build them out as wide as you want using more GEN2 Size Adapter Covers in both 1W and 2W.

Page updated

Google Sites

Report abuse